The use of Bricks or Pavers to create a sidewalk or patio complements a house in a method that is unrivaled. In addition, installing a Brick or Paver sidewalk does not always need a pro.
The secret to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. The area must be dug out at least a foot down, eliminating all topsoil and clay soil. In addition, string lines need to be strung on each side of the pathway. The string lines indicate the completed height of the sidewalk.
Once the area has been dug down, 3/4" gravel stone ought to be laid in and tamped down securely. The height in between the tamped down sand and the stringline ought to equal the density of the brick or paver.
Now that you have a stable base, position a 1" pipeline or journal board the length of the walkway on either side of the walkway. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will act as your walkway border and aid to maintain the stability and shape of the pathway.
As soon as this is done, you can then start to lay the bricks/pavers. There are numerous patterns you can lay. I particularly like the Herring Bone pattern. The key to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the integrity of the walkway.
Undoubtedly bricks/pavers will need to be cut or divided when constructing the sidewalk. Unless you desire to purchase or rent a costly wetsaw, I would suggest acquiring an easy brick/paver splitter. It is basically a chisel with a wide end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you desire to break the brick. Utilizing a hammer strike the butt end of the chisel strongly. You may require to do this a couple of times. You might likewise desire to turn the brick/paver over and strike the other side read more of the brick utilizing the hammer and chisle. Within one or 2 strikes the brick/paver should break easily. , if your sidewalk has curves you will require to buy/rent a wetsaw.
.
After setting up the bricks, develop the outside edges with additional sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the new sidewalk and sweep into the fractures. This will finish the interlocking of the bricks and assist to get rid of any weed development.
In addition, setting up a Brick or Paver sidewalk does not always need a pro. The secret to installing a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, position a 1" pipeline or ledger board the length of the pathway on either side of the walkway. These strips will act as your walkway border and assistance to preserve the integrity and shape of the walkway. Undoubtedly bricks/pavers will require to be cut or divided when developing the pathway.